This tool needs Google Chrome or Microsoft Edge on a laptop/desktop.
The Web Serial API is not available in this browser (phones and Safari are not supported).
You can still use TeraTerm as described in your logger manual.
Logger went to sleep (or its menu expired).
Unplug the USB cable from your computer and plug it back in — the logger wakes to its menu and this page reconnects automatically.
1. Connect Logger dataloggers #1000 and above
Turn the logger on, attach the custom USB cable to the 8-pin (pressure switch) connector, plug it into this computer, then click Connect. The logger shows its menu for ~2 minutes after the USB is plugged in.
Check Logger manufacturing bench
Board programmed with the Flasher (green light), 8-pin connected, switch ON
The standard probe plugged into port 1
The pressure-switch jumper within reach
A new board takes the number you type; the check first makes sure it has not been given to another logger. Then it holds the firmware to the production release, the battery to the bench floor, reads both ports with the standard probe, watches the pressure switch under the jumper, uploads once, and says GOOD or BAD. Do what the screen says.
2. Logger Status
screen: —
⚠ SD-ONLY (OFFLINE) MODE IS ON — this logger will not upload data to the dashboard.
3. Health Checks
4. Logger Actions
Crash / reset log EEPROM fault ring (issue #132)
Raw output
Plug a standard test probe into each port and verify mV/V + Ω. Short the pressure-switch port to test it.
—
Advanced / danger zone
Factory reset returns APN, hibernation, SD settings and counters to defaults. Type RESET to enable the button.
5. Probe Calibrations for SD-card / offline data
Enter the probe name printed on each probe's white label, then click “Look up.” No login needed — the calibration coefficients are fetched from FloraPulse by probe name (or from this page's offline cache when you have no internet) and typed into the logger for you. Calibrations only affect SD-card data; dashboard data is calibrated in the cloud automatically.
6. Prepare for the Field work without internet
Open this page once while online and it keeps working offline (it is saved to your browser). Every probe you look up in section 5 is cached automatically — no login needed. The button below is an optional shortcut: while signed in to the FloraPulse dashboard, it bulk-caches the calibration coefficients for all probes on your account at once, so everything above works in the middle of the orchard with zero signal.
7. Raw Terminal everything TeraTerm shows, live
Click the terminal and type to talk to the logger directly — 1–9 menu choices, Esc back, Enter confirm. Disabled while an automated action is running.
After an Upload now or a factory reset, this page sends FloraPulse a copy of that session's log (right away when online) so we can diagnose upload problems. Offline, it waits in this browser and goes the next time this page is open on a computer with internet. It holds only what the logger printed, without its ingest key.
Activity
FloraPulse Datalogger Toolkit · for 4G loggers #1000+ · works offline once loaded ·
sends FloraPulse the log of each Upload now / factory reset ·
fallback: TeraTerm per your logger manual
Datalogger Toolkit